Plug-in Reference

114
The Included Effect Plug-ins
Tools Plug-ins
closer speaker so that the sound from it arrives at the same time as the sound from the
more distant speakers. Note that MixerDelay has a wide range (up to 1000
ms) and
fine adjustments are best made by numerically entering the delay time in centimeters
for speaker alignment.
Tools Plug-ins
This section describes the plug-ins in the “Tools” category.
MultiScope
MultiScope can be used for viewing the waveform, phase linearity or frequency
content of a signal. There are three different modes:
- Oscilloscope (Ampl.)
- Phase Correlator (Scope)
- Frequency Spectrum Analyzer (Freq.)
Ö The Freeze button can be used to freeze the display in all three modes. Click it again
to exit freeze mode.
Oscilloscope Mode (Ampl.)
• To view a signal waveform, open the MultiScope control panel and make sure that
the “Ampl.” button in the lower left corner is lit.
• If the source signal is stereo you can now select either the Left or Right channel for
viewing, or Stereo for both channels to be shown in the window. If it is a mono
signal, this does not matter.
• If MultiScope is used with a multi-channel track or output bus, you can select any
speaker channel for viewing, or All Channels to view them all at once.
• You can now adjust the Amplitude knob to increase/decrease the vertical size of
the waveform, and the Frequency knob to select the frequency area for viewing.
!
The MixerDelay is not a mixer – the number of outputs is the same as the number of
inputs. If you need to mix down a surround signal to stereo, use the Mix6to2, Mix8to2
or MixConvert
V6 plug-ins.
Cubase
LE
Cubase
AI
Cubase
Elements
Cubase
Artist
Cubase Nuendo NEK
Included with
– – – – X X –