Plug-in Reference

90
The included VST instruments
Ö To ensure MIDI control compatibility, the saved
scenes are shifted to the scene pads 13-24, i. e., the
scene on pad 1 is shifted to pad 13, the scene on pad 2
to pad 14, and so on.
Monologue – Monophonic Analog
Modeling Synthesizer (Cubase only)
Monologue is a monophonic analog synthesizer based on
physical modeling technology. It offers full, rich and color
-
ful sounds without consuming a lot of CPU power. The
Monologue synthesizer is the perfect tool for bass, lead
and sequenced sounds.
The Monophonic Analog Modeling Synthesizer has the
following properties:
• 2 oscillators with sawtooth, square and triangle waveforms.
• An additional noise generator for white noise.
• Monologue has two filters: a high pass filter and a versatile
multimode filter.
• Monologue has a single LFO.
• Monologue has 4-stage ADSR mod and amp envelopes.
• Monologue has an effects section with chorus, phaser, and
flanger effects, plus separate delay and overdrive units.
• Monologue has a X/Y matrix pad for additional realtime modu-
lation with access to all Monologue parameters.
Osc 1 and 2
In the OSC 1 and OSC 2 sections, the following parame-
ters are available:
Mix
In the Mix section, the following parameters are available:
Filter
In the Filter section, the following parameters are available:
Parameter Description
Waveform
(pop-up menu)
This is where you select the waveform: Saw, Square and
Sub for oscillator 1 and Saw, Square and Triangle for Os
-
cillator 2.
Coarse Sets the coarse pitch in semitones. The available range is
±1 octave.
Fine Allows you to fine-tune the pitch in cent increments. The
available range is ±50 cents.
Depth Controls the pitch modulation depth for the mod source
defined in the “mod src” field. The available range is ±1
octave.
Mod Src Defines the pitch modulation source. Available sources
are: Modwheel, Aftertouch, Pitchbend, Velocity, LFO and
Mod Env.
PWM
(OSC2 only)
Controls the pulse width of the square wave. In the center
position, pulse width is 50/50. Turning the PWM knob
clockwise or counter clockwise creates a positive or neg
-
ative pulse, respectively.
Sync
(OSC2 only)
Activating the sync button synchronizes the pitch of oscil-
lator 2 to the pitch of oscillator 1. When this is active,
changing or modulating the pitch of oscillator 2 changes
the tone and not the pitch. For the typical sync sound,
turn osc 1 down in the mix and use osc 2 only.
Parameter Description
Osc 1 Sets the pre-filter level for oscillator 1.
Noise Sets the pre-filter noise level.
Osc 2 Sets the pre-filter level for oscillator 2.
Parameter Description
Mode Sets the filter type. Available filter types are 24 dB Low
pass, 18
dB Low pass, 12 dB Low pass, 6 dB Low pass,
12
dB Band pass and 12 dB High pass.
Cutoff Sets the filter cutoff frequency. How this parameter oper-
ates is governed by the filter type.
High Pass Sets the cutoff frequency of the additional high-pass filter.
Res Changes the resonance of the multi-mode filter. Full res-
onance puts the filter into self-oscillation.