Plug-in Reference

8
The included effect plug-ins
PingPongDelay
This is a stereo delay effect that alternates each delay re-
peat between the left and right channels. The effect can
either be tempo-based or use freely specified delay time
settings.
The following parameters are available:
Ö The delay can also be controlled from another signal
source via the side-chain input. When the side-chain sig
-
nal exceeds the threshold, the delay repeats are silenced.
When the signal drops below the threshold, the delay re
-
peats reappear. For a description of how to set up side-
chain routing, see the chapter “Audio effects” in the Oper
-
ation Manual.
StereoDelay
StereoDelay has two independent delay lines which either
use tempo-based or freely specified delay time settings.
The following parameters are available:
Ö The delay can also be controlled from another signal
source via the side-chain input. When the side-chain sig-
nal exceeds the threshold, the delay repeats are silenced.
When the signal drops below the threshold, the delay re
-
peats reappear. For a description of how to set up side-
chain routing, see the chapter “Audio effects” in the Oper
-
ation Manual.
Parameter Description
Delay If tempo sync is on, this is where you specify the base
note value for the delay (1/1–1/32, straight, triplet, or
dotted).
If tempo sync is off, the delay time can be set freely in
milliseconds.
Sync button The button below the Delay Time knob is used to switch
tempo sync on or off.
Feedback Sets the number of repeats for the delay.
Filter Lo This filter affects the feedback loop and allows you to roll
off low frequencies up to 800
Hz. The button below the
knob activates/deactivates the filter.
Filter Hi This filter affects the feedback loop and allows you to roll
off high frequencies from 20
kHz down to 1.2 kHz. The
button below the knob activates/deactivates the filter.
Spatial Sets the stereo width for the left/right repeats. Turn
clockwise for a more pronounced stereo “ping-pong” ef
-
fect.
Mix Sets the level balance between the dry and the wet sig-
nal. If PingPongDelay is used as a send effect, set this to
the maximum value as you can control the dry/effect bal
-
ance with the send.
Parameter Description
Delay 1 & 2 If tempo sync is on, this is where you specify the base
note value for the delay (1/1–1/32, straight, triplet, or
dotted).
If tempo sync is off, the delay time can be set freely in
milliseconds.
Sync button The buttons below the Delay knobs are used to turn
tempo sync on or off for the respective delay.
Feedback
1 & 2
The Feedback controls set the number of repeats for
each delay.
Filter Lo
1 & 2
These filters affect the feedback loop and allow you to roll
off low frequencies up to 800
Hz. The buttons below the
knobs activate/deactivate the filter.
Filter Hi
1 & 2
These filters affect the feedback loop and allow you to roll
off high frequencies from 20
kHz down to 1.2 kHz. The
buttons below the knobs activate/deactivate the filter.
Pan 1 & 2 These controls are used to set the stereo position for
each delay.
Mix 1 & 2 Use these controls to set the level balance between the
dry and the wet signal. If StereoDelay is used as a send
effect, set them to the maximum value (100
%) as you can
control the dry/effect balance with the send.