Plug-in Reference

7
The included effect plug-ins
MonoDelay
This is a mono delay effect that can either be tempo-
based or use freely specified delay time settings.
The following parameters are available:
Ö The delay can also be controlled from another signal
source via the side-chain input. When the side-chain sig-
nal exceeds the threshold, the delay repeats are silenced.
When the signal drops below the threshold, the delay re
-
peats reappear. For a description of how to set up side-
chain routing, see the chapter “Audio effects” in the Oper
-
ation Manual.
Range Lo/Hi These knobs specify the range (in Hz) of the filter fre-
quency modulation. Both positive (e. g. Lo set to 50 and
Hi set to 10000) and negative (e.
g. Lo set to 5000 and
Hi set to 500) ranges can be set. If tempo sync is off and
the Speed is set to zero, these parameters are inactive
and the filter frequency is controlled by the Freq parame
-
ter instead.
Spatial Introduces an offset between the channels to create a
stereo panorama effect for the filter frequency modula
-
tion. Turn clockwise for a more pronounced stereo ef-
fect.
Q-Factor Controls the resonance of the filter. It is only available if
filter resonance LFO tempo sync is deactivated and the
Speed parameter (see below) is set to “0”. When using
tempo sync, the resonance is controlled by the Speed
and Range parameters.
Speed Sets the speed of the filter resonance LFO modulation.
When using tempo sync, the Speed parameter sets the
base note value for tempo syncing the modulation (1/1
to 1/32, straight, triplet, or dotted). If tempo sync is off,
the speed can be set freely.
Speed –
Sync button
The button below the Speed knob is used to switch
tempo sync for the Speed parameter on or off.
Range Lo/Hi These knobs specify the range of filter resonance
modulation. Both positive (e.
g. Lo set to 50 and Hi set
to 100) and negative (e.
g. Lo set to 100 and Hi set to
50) ranges can be set. If tempo sync is off and the
Speed is set to zero, these parameters are inactive and
the filter resonance is controlled by the Q-Factor pa
-
rameter instead.
Spatial Introduces an offset between the channels to create a
stereo panorama effect for the filter resonance modu
-
lation. Turn clockwise for a more pronounced stereo
effect.
Parameter Description
Parameter Description
Delay If tempo sync is on, this is where you specify the base
note value for the delay (1/1–1/32, straight, triplet, or
dotted).
If tempo sync is off, the delay time can be set freely in
milliseconds.
Sync button The button below the Delay knob is used to switch tempo
sync on or off.
Feedback Sets the number of repeats for the delay.
Filter Lo This filter affects the feedback loop of the effect signal
and allows you to roll off low frequencies from 10
Hz up to
800
Hz. The button below the knob activates/deactivates
the filter.
Filter Hi This filter affects the feedback loop of the effect signal
and allows you to roll off high frequencies from 20
kHz
down to 1.2
kHz. The button below the knob activates/
deactivates the filter.
Mix Sets the level balance between the dry and the wet sig-
nal. If MonoDelay is used as a send effect, set this to the
maximum value as you can control the dry/effect balance
with the send.