Plug-in Reference

51
The included effect plug-ins
Tuner
This is a guitar tuner. Simply connect a guitar or other in-
strument to an audio input and select the Tuner as an in-
sert effect (make sure you deactivate any other effect that
alters pitch, like chorus or vibrato).
When you play a note, the pitch is shown in the middle of
the display. In addition, the frequency in Hz is shown in the
bottom left corner and the octave range in the bottom right
corner.
The two arrows indicate any deviation in pitch. If the pitch
is flat, they are positioned in the left half of the display, if
the pitch is sharp they are in the right half. The deviation is
also shown (in Cent) in the upper area of the display.
• If a string is out of tune (e. g. if the pitch for the E string
is shown as Eb), tune the string so that the correct pitch is
shown and the two arrows are in the middle.
Repeat this procedure for each string.
• To mute the output signal so that you can tune the
strings in silence, activate the Mute button at the bottom
middle of the plug-in panel.
Frequency
section
Allows you to set the frequency of the generated signal.
You can select one of the preset values (100, 440, 1000,
or 10000
Hz), or use the slider to set a value between
1
Hz and 20000 Hz.
Gain section Allows you to set the amplitude of the signal. The higher
the value (up to 0
dB), the stronger the signal. You can
select one of the preset values (e.
g. -20 dB), or use the
slider to set a value between -81 and 0
dB.
Parameter Description