Plug-in Reference

36
The included effect plug-ins
Ö The modulation can also be controlled from another
signal source via the side-chain input. When the side-
chain signal exceeds the threshold, the modulation is con-
trolled by the side-chain signal’s envelope. For a descrip-
tion of how to set up side-chain routing, see the chapter
“Audio effects” in the Operation Manual.
Tranceformer
Tranceformer is a ring modulator effect, in which the in-
coming audio is ring modulated by an internal, variable fre-
quency oscillator, producing new harmonics. A second
oscillator can be used to modulate the frequency of the
first oscillator, in sync with the Song tempo if needed.
The following parameters are available:
Ö Note that clicking and dragging in the display allows
you to adjust the Tone and Depth parameters at the same
time!
Tremolo
Tremolo produces amplitude (volume) modulation. The
following parameters are available:
Ö The modulation can also be controlled from another
signal source via the side-chain input. When the side-
chain signal exceeds the threshold, the modulation is con
-
trolled by the side-chain signal’s envelope. For a descrip-
tion of how to set up side-chain routing, see the chapter
“Audio effects” in the Operation Manual.
Delay Affects the frequency range of the modulation sweep
by adjusting the initial delay time.
Filter Lo/Hi Allow you to roll off low and high frequencies of the ef-
fect signal.
Parameter Description
Waveform
buttons
Allow you to select a pitch modulation waveform.
Tone Sets the frequency (pitch) of the modulating oscillator
(1
to 5000 Hz).
Depth Governs the depth of the pitch modulation.
Speed If tempo sync is on, this is where you specify the base
note value for tempo-syncing the effect (1/1 to 1/32,
straight, triplet, or dotted). Note that there is no note
value modifier for this effect.
If tempo sync is off, the modulation speed can be set
freely with the Speed knob.
Parameter Description
Sync button The button above the Speed knob is used to switch
tempo sync on (button lights up) or off.
On button Turns modulation of the pitch parameter on or off.
Mono button Governs whether the output is stereo or mono.
Output slider Allows you to adjust the output level of the effect.
Mix slider Sets the level balance between the dry and the wet sig-
nal.
Parameter Description
Rate If tempo sync is on, this is where you specify the base
note value for tempo-syncing the effect (1/1 to 1/32,
straight, triplet, or dotted).
If tempo sync is off, the modulation speed can be set
freely with the Rate knob.
Sync button The button below the Rate knob is used to switch tempo
sync on or off.
Depth Governs the depth of the amplitude modulation.
Spatial Adds a stereo effect to the modulation.
Output Allows you to adjust the output volume.
Parameter Description