Plug-in Reference

32
The included effect plug-ins
Flanger
Flanger is a classic flanger effect with added stereo
enhancement.
The following parameters are available:
Ö The modulation can also be controlled from another
signal source via the side-chain input. When the side-
chain signal exceeds the threshold, the modulation is con
-
trolled by the side-chain signal’s envelope. For a descrip-
tion of how to set up side-chain routing, see the chapter
“Audio effects” in the Operation Manual.
Static Detune
button
Use this button to activate/deactivate the Static Detune
function. If activated, the set detune amount is static, and
the Humanize knob is grayed out.
Delay Governs the overall depth of the delay for all voices. If set
to zero, no delay takes place regardless of the Delay
slider settings.
Delay –
Humanize
Controls the amount of delay variation when Static De-
tune is deactivated. With Humanize, the delay is con-
stantly modulated for a more natural effect. The value
range is from 0 to 100 (strongest delay variation).
Static Delay
button
Use this button to activate/deactivate the Static Delay
function. If activated, the set delay amount is static, and
the Humanize knob is grayed out.
Parameter Description
Rate If tempo sync is on, this is where you specify the base
note value for tempo-syncing the flanger sweep (1/1 to
1/32, straight, triplet, or dotted).
If tempo sync is off, the sweep rate can be set freely with
the Rate knob.
Sync button The button below the Rate knob is used to switch tempo
sync on or off.
Range Lo/Hi Set the frequency boundaries for the flanger sweep.
Feedback Determines the character of the flanger effect. Higher
settings produce a more “metallic” sounding sweep.
Spatial Sets the stereo width of the effect. Turn clockwise for a
wider stereo effect.
Parameter Description
Mix Sets the level balance between the dry and the wet sig-
nal. If Flanger is used as a send effect, set this to the max-
imum value as you can control the dry/effect balance with
the send.
Waveform
Shape selector
Allows you to select the modulation waveform, altering
the character of the flanger sweep. A sine and a triangle
waveform are available.
Delay Affects the frequency range of the modulation sweep by
adjusting the initial delay time.
Manual knob Allows you to change the sweep position manually when
the Manual button is deactivated. The value range is from
0 to 100.
Manual button Use this button to activate/deactivate the Manual func-
tion. If activated, the flanger sweep is static, i. e. no mod-
ulation takes place.
Filter Lo/Hi Allow you to roll off low and high frequencies of the effect
signal.
Parameter Description