Plug-in Reference

30
The included effect plug-ins
Modulation plug-ins
This section contains descriptions of the plug-ins in the
“Modulation” category.
AutoPan
This is a simple auto-pan effect. It can use different wave-
forms to modulate the left-right stereo position (pan), ei-
ther using tempo sync or manual modulation speed
settings.
The following parameters are available:
Ö The Width parameter can also be controlled from an-
other signal source via the side-chain input. For a descrip-
tion of how to set up side-chain routing, see the chapter
“Audio effects” in the Operation Manual.
Chopper
Chopper is a combined tremolo and autopan effect. It can
use different waveforms to modulate the level (tremolo) or
left-right stereo position (pan), either using tempo sync or
manual modulation speed settings.
The following parameters are available:
Parameter Description
Rate If tempo sync is on, this is where you specify the base
note value for tempo-syncing the effect (1/1 to 1/32,
straight, triplet, or dotted).
If tempo sync is off, the auto-pan speed can be set freely
with the Rate knob.
Sync button The button below the Rate knob is used to switch tempo
sync on or off.
Width Sets the depth of the auto-pan effect.
Waveform
Shape selector
Allows you to select the modulation waveform. A sine and
a triangle waveform are available.
Parameter Description
Waveform
buttons
Set the modulation waveform.
Depth Sets the depth of the Chopper effect. This can also be
set by clicking in the graphical display.
Speed If tempo sync is on, this is where you specify the base
note value for tempo-syncing the effect (1/1 to 1/32,
straight, triplet, or dotted). Note that there is no note
value modifier for this effect.
If tempo sync is off, the tremolo/auto-pan speed can be
set freely with the Speed knob.
Sync button The button above the Speed knob is used to switch
tempo sync on (button lights up) or off.
Stereo/Mono
button
Determines whether the Chopper works as an auto-pan-
ner (button set to “Stereo”) or a tremolo effect (button set
to “Mono”).
Mix Sets the level balance between the dry and the wet sig-
nal. If Chopper is used as a send effect, this should be
set to the maximum value.