Plug-in Reference

105
The included VST instruments
Modulation and controllers
The lower half of the control panel displays the various
modulation and controller assignment pages available as
well as the effect page. You switch between these pages
using the buttons below the Filter section.
The following pages are available:
• The LFO page has two low frequency oscillators (LFOs)
for modulating parameters – see below.
• The Envelope page contains the four Envelope genera-
tors which can be assigned to control parameters – see
“Envelope page” on page 106.
• The Event page contains the common MIDI controllers
(Mod wheel, Aftertouch, etc.) and their assignments – see
“Event page” on page 108.
• The Effect page has three separate effect types avail-
able; Distortion, Delay and Modulation – see “Effects
(EFX) page” on page 109.
LFO page
The LFO page is opened by clicking the LFO button at the
top of the lower half of the control panel. The page contains
all parameters and the modulation and velocity destinations
for two independent LFOs.
Depending on the currently selected preset, there may al-
ready be modulation destinations assigned, in which case
these are listed in the “Mod Dest” box for each LFO – see
“Assigning LFO modulation destinations” on page 106. A
low frequency oscillator (LFO) is used for modulating pa-
rameters, for example the pitch of an oscillator (to produce
vibrato), or for any parameter where cyclic modulation is
desired.
The two LFOs have identical parameters:
About the sync modes
The Sync modes determine how the LFO cycle affects the
notes you play:
About the waveforms
Most standard LFO waveforms are available for LFO modu-
lation. You use Sine and Triangle waveforms for smooth
modulation cycles, Square and Ramp up/down for different
types of stepped modulation cycles and Random or Sam
-
ple for random modulation. The Sample waveform is differ-
ent. In this mode, one LFO actually samples and holds the
values of the other LFO at the chosen frequency.
Parameter Description
Speed This governs the rate of the LFO. If MIDI Sync is activated
(see below), the available rate values are selectable as
note values, e.
g. beat increments of the sequencer tempo
in Cubase.
Depth This controls the amount of modulation applied by the
LFO. If set to zero, no modulation is applied.
Waveform This sets the LFO waveform.
Sync mode
(Part/MIDI/
Voice/Key)
This sets the sync mode for the LFO. See below for a de-
scription.
Parameter Description
Part In this mode, the LFO cycle is free running and affects all
the voices in sync. “Free running” means that the LFO cy
-
cles continuously, and does not reset when a note is
played.
MIDI In this mode the LFO rate is synced in various beat incre-
ments to MIDI clock.
Voice In this mode each voice in the Part has its own indepen-
dent LFO cycle (the LFO is polyphonic). These cycles are
also free running – each key down starts anywhere in the
LFO cycle phase.
Key Same as Voice except that it is not free running – for
each key down the LFO cycle starts over.