Plug-in Reference

76
The included VST Instruments
Depending on the selected page (Play, Voice, Filter, Am-
plifier), up to six quick controls with different pad-specific
parameter assignments are displayed.
Play parameters
Ö The parameter controls on the Play page are copies of
the same parameters on the Voice, Filter and Amplifier
pages.
The row of parameter controls below the LCD display
shows six parameters:
Voice parameters
The row of parameter controls below the LCD display
shows six parameters:
Filter parameters
The row of parameter controls below the LCD display
shows four parameters used to edit the Groove Agent
ONE filter:
Amplifier parameters
The row of parameter controls below the LCD display
shows six parameters:
MIDI input off When the MIDI symbol button in the top right corner of
the LCD display is activated, the LCD display will show
the waveform and parameter values of the currently play-
ing sample. When this button is deactivated, the display
will show only the data for the currently edit selected
sample.
Layer indicator The long bar near the top of the LCD display shows the
active layer for the current pad. If more than one layer ex-
ist for the selected pad, the bar is divided accordingly.
You can drag the dividing line between layers to change
the velocity ranges of the layers. You can drag a new
sample from the MediaBay and drop it directly onto the
Layer indicator bar (this is the same as dropping a sam-
ple on a pad). You can drag layers to a different position
on the bar.
Layer number The layer number indicates which is the active layer of the
current pad.
Sample This is the name of the sample file.
Velocity Here you can specify a velocity range for the current
layer.
Coarse Here you can tune the sample by up to ±12 semitones.
Fine This parameter lets you finetune the sample by up to
±100 cents.
Volume Sets the sample volume.
Waveform The waveform of the current sample.
Parameter Description
Volume The volume of the pad currently selected for editing.
Pan The panorama setting of the pad currently selected for
editing.
Coarse Use this control to tune the pad by up to ±12 semitones.
Cutoff Sets the filter cutoff frequency.
Q Sets the filter resonance.
Output Groove Agent ONE provides up to 16 stereo outputs.
You can route pads to individual outputs using this con-
trol.
Parameter Description
Parameter Description
Mode Here you can reverse the currently selected sample so
that you hear it backwards.
Coarse Use this control to tune the pad by up to ±12 semitones.
Fine Use this control to finetune the pad by up to ±100 cents.
Mute Gr. With this control you can assign a pad to one of eight
mute groups. Pads within a mute group will never play
back simultaneously. New notes will cancel previous
notes.
Tr. Mode The sample of the currently selected pad is played either
from start to finish (One Shot) or only for as long as you
hold the mouse button/key (Key Hold). Key Hold can also
be determined by the length of the corresponding MIDI
note on your track.
Output Groove Agent ONE provides up to 16 stereo outputs.
You can route pads to individual outputs using this con-
trol. See the Operation Manual for information on how to
use multitimbral instruments in Cubase.
Parameter Description
Type Sets the filter type: low-pass (LP), high-pass (HP) or
band-pass (BP). When you set this knob to OFF, the set-
tings on this editing page have no effect.
Cutoff Sets the filter cutoff frequency.
Q Sets the filter resonance.
Mod This parameter determines the influence that velocity has
on the cutoff frequency. When set to 0%, the setting has
no effect. When set to any other value, the cutoff fre-
quency changes depending on the velocity.
Parameter Description
Volume The volume of the pad currently selected for editing.
Pan The panorama setting of the pad currently selected for
editing.
Attack Controls the amplifier envelope attack time.