User manual

19
VST Connections: Setting up input and output busses
Input channels (Cubase only)
The input channels are shown to the left in the mixer. As
you can see, each input channel resembles a regular mixer
channel strip. Here you can do the following:
• Check and adjust the recording level using the Input
Gain knobs and/or the level fader.
See “Setting input levels” on page 70.
• Change the phase of the input signal.
This is done by clicking the Input Phase button next to the Input Gain
control.
• Add effects or EQ to the input bus.
See “Recording with effects (Cubase only)” on page 77 for an example
of how to add effects to your recording at the input bus stage.
Output channels
The output channels are shown to the right in the mixer.
Here you can do the following:
• Adjust the output level for the busses with the faders.
• Add effects or EQ.
These will affect the whole bus. Examples of effects you may want to add
here include compressors, limiters and dithering. See the chapter “Audio
effects” on page 162.
!
The settings you make in the input channel strip will
be a permanent part of the recorded audio file!