Remote Control Devices

13
Remote controlling Cubase
JL Cooper CS-10
The CS-10 can remote control 32 channels (in groups of
8). The following CS-10 controls will remote control the
following parameters for each channel strip:
•Fader: volume
• Solo and Mute: solo and mute
• Sel: select channel for editing
The following parameters can be remote controlled for each
selected channel using the six rotary knobs on the CS-10:
• The CS-10 function keys 1–4 are used to select chan-
nels 1–32 in groups of 8.
Function key 1 selects channels 1–8, function key 2 selects channels 9–
16, and so on.
• If you hold down the function key “Shift” and then move
a fader, the two indicators beside the fader will indicate
whether the fader position is below or above the current
fader level in Cubase.
If the upper indicator is lit, the fader position on the panel is above the
fader level in Cubase and vice versa. When both indicators are dark, the
fader positions are matched for that channel.
• The CS-10 Play, Stop, Record, Rewind and Fast For-
ward transport controls control the equivalent functions in
Cubase.
JL Cooper MCS-3000
The MCS-3000 can control 32 mixer channels remotely
(in groups of 8). The following MCS-3000 controls will re-
mote control the following mixer parameter for each chan-
nel strip:
• Fader: volume
• Solo and Mute: solo and mute
• Sel: Select channel for editing
These parameters can be remote controlled for each selected channel
using the dials on the MCS-3000 and switching between Pages 1–4:
• The MCS-3000 bank keys 1–4 are used to select
channels 1–32 in groups of 8.
Bank key 1 selects channels 1–8, bank key 2 selects channels 9–16, etc.
• You can create markers by pressing the “Set Locate”
key on the MCS-3000, typing in a marker ID and pressing
[Return].
• To locate to a marker, press “Locate”, type in a marker
ID and press [Return].
Dial Parameter
Send 1 Effect send 1
Send 2 Effect send 2
Pan Pan
Boost/cut EQ 1 Gain
Frequency EQ 1 Frequency
Bandwidth EQ 1 Q Factor
!
The CS-10 supports “MIDI Feedback”, allowing the
mute, solo and selection status of channels in Cubase
to be indicated on the panel. For this (and the fader
position indication described above) to work, you
need a two-way MIDI connection between the CS-10
and Cubase.
Page 1 Page 2
Dial Parameter Dial Parameter
1Pan1EQ 1 Gain
2 Effect send 1 2 EQ 1 Freq
3 Effect send 2 3 EQ 1 “Q”
4 Effect send 3 4 EQ 1 Low Limit
5 Effect send 4 5 EQ 1 High Limit
Page 3 Page 4
Dial Parameter Dial Parameter
1 EQ 2 Gain 1 EQ 3 Gain
2 EQ 2 Freq 2 EQ 3 Freq
3 EQ 2 “Q” 3 EQ 3 “Q”
4 EQ 2 Low Limit 4 EQ 3 Low Limit
5 EQ 2 High Limit 5 EQ 3 High Limit