Remote Control Devices

11
Remote controlling Cubase
• In the View section, select Write or “fnct B” to control
the Write or Read buttons in the Cubase mixer. When
Write/fnct B is selected, selecting the All button in the
bottom left section of the CM Motor Mix controls the Write
All/Read All buttons in the Cubase mixer.
• The Auto Enbl button controls Start/Stop in Cubase.
• The Suspend button controls the Record function in
Cubase.
• Press the DSP button to move the project cursor to the
start of the project.
Hold down Shift and press the DSP button to move the project cursor to
the end of the project.
• Press the Window button to move the project cursor to
the left locator.
Hold down Shift and press the Window button to move the project cur-
sor to the right locator.
• Press the Default button to switch automatic punch in
on or off.
Hold down Shift and press the Default button to switch automatic punch
out on or off.
• Press the Undo button to undo the last action in Cu-
base.
Hold down Shift and press the Undo button to “undo the undo”.
In the Rotary section, use the Rotary dial to change the as-
signment of the four buttons below the dial (indicated in
the ROTARY display):
ROTARY: PA
• equaliz button: Fader Set mode Panning
• dynmics button: Fader Set mode Routing
• delay button: Selected Channel mode Panning
• special button: Selected Channel mode Routing
ROTARY: EQ
• equaliz button: Fader Set mode EQ Low (EQ1)
• dynmics button: Fader Set mode EQ Mid-Low (EQ2)
• delay button: Fader Set mode EQ Mid-High (EQ3)
• special button: Fader Set mode EQ High (EQ4)
ROTARY: S1
• equaliz button: Fader Set mode Send 1
• dynmics button: Fader Set mode Send 2
• delay button: Fader Set mode Send 3
• special button: Fader Set mode Send 4
ROTARY: S2
• equaliz button: Fader Set mode Send 5
• dynmics button: Fader Set mode Send 6
• delay button: Fader Set mode Send 7
• special button: Fader Set mode Send 8
• Use the Bank Up button in the View section for page up.
Hold down Shift and press the Bank Up button to jump to the last page.
• Use the Bank Down button in the View section for page
down.
Hold down Shift and press the Bank Down button to jump to the first page.
• Press the Rotary dial to switch the display of names of
the available parameters or the page name on or off.
Fader Set mode Panning:
• Page 1 – panning left/right
• Page 2 – panning front/rear
• Buttons below dials: monitor
Fader Set mode Routing:
• Page 1 – Output Bus
•Page 2 – Monitor
•Page 3 – Input Bus
•Page 4 – Input Gain
•Page 5 – Input Phase
• Buttons below dials: monitor
Selected Channel mode Panning:
• Page 1 – panning left/right, panning front/rear
• Buttons below dials: monitor
Selected Channel mode Routing:
• Page 1 – Output Bus, Monitor, Input Bus, Input Gain, Input
Phase
• Buttons below dials: monitor