Quick Start
Table Of Contents
- English
- Table of Contents
- Introduction
- System requirements and installation
- Setting up your system
- Tutorial 1: Recording audio
- Tutorial 2: Editing audio
- Tutorial 3: Recording and editing MIDI
- Tutorial 4: Working with loops
- Tutorial 5: External MIDI instruments
- Tutorial 6: Mixing and effects
- Tutorial 7: Surround production (Cubase only)
- Tutorial 8: Editing audio II - tempo and groove
- Tutorial 9: Media management
- Index
- Deutsch
- Inhaltsverzeichnis
- Einleitung
- Systemanforderungen und Installation
- Einrichten des Systems
- Lehrgang 1: Aufnehmen von Audiomaterial
- Lehrgang 2: Bearbeiten von Audiomaterial
- Lehrgang 3: Aufnehmen und Bearbeiten von MIDI
- Lehrgang 4: Arbeiten mit Loops
- Lehrgang 5: Externe MIDI-Instrumente
- Lehrgang 6: Anwenden von Effekten und Erstellen eines Mixdowns
- Lehrgang 7: Surround-Sound (nur Cubase)
- Lehrgang 8: Bearbeiten von Audiomaterial II - Tempo und Groove
- Lehrgang 9: Medienverwaltung
- Stichwortverzeichnis
- Français
- Table des Matières
- Introduction
- Système requis et installation
- Configuration de votre système
- Didacticiel 1 : Enregistrement audio
- Didacticiel 2 : Édition Audio
- Didacticiel 3 : Enregistrement et édition MIDI
- Didacticiel 4 : Travailler avec des boucles
- Didacticiel 5 : Instruments MIDI Externes
- Didacticiel 6 : Mixage et Effets
- Didacticiel 7 : Production Surround (Cubase uniquement)
- Didacticiel 8 : Édition Audio II - Tempo et Groove
- Didacticiel 9 : Organisation des fichiers de media
- Index
77
Tutorial 8: Editing audio II - tempo and groove
5. Activate Preview.
The drum loop is now matched to the tempo of the project.
6. Close the Sample Editor.
7. Select the drum loop in the project window and select
Loop Selection from the Transport menu.
You can also use the corresponding key command [Shift]+[G].
You can now hear that the drum loop is in perfect time
with the project tempo. Feel free to change the tempo on
the Transport panel by deactivating the Tempo Track. The
drum loop will follow.
Example 2: Drum loop, Auto Adjust
In this example we have imported a drum loop and we do
not know the tempo. This is one of the quickest ways to
match the tempo of the drum loop with the project tempo.
1. Activate Start on the Transport panel.
You will hear that the drum loop is off time with the click.
2. Activate Stop and deactivate the Click.
3. Double-click on the drum loop.
The Sample Editor will open.
4. Click on the Definition tab and activate Preview.
Activating Preview allows you to hear any tempo changes directly.
5. Zoom in on the first bar.
You can use the zoom slider on the bottom right. Zoom in so that you can
see about 18 waveform shaker hits.
Activate Preview
!
Load the project called “Tempo and Groove 2” found
in the “Tutorial 8” folder.
Definition tab
Activate Preview
Zoom slider
1-8 9-16 17-18