Plug-in Reference

71
The included VST Instruments
Monologue – Monophonic Analog
Modeling Synthesizer (Cubase only)
Monologue is a monophonic analog synthesizer based on
physical modeling technology. It offers full, rich and color-
ful sounds without consuming a lot of CPU power. The
Monologue synthesizer is the perfect tool for bass, lead
and sequenced sounds.
The Monophonic Analog Modeling Synthesizer has the
following properties:
• 2 oscillators with sawtooth, square and triangle waveforms.
• An additional noise generator for white noise.
• Monologue has two filters: a high pass filter and a versatile
multimode filter.
• Monologue has a single LFO.
• Monologue has 4-stage ADSR mod and amp envelopes.
• Monologue has an effects section with chorus, phaser, and
flanger effects, plus separate delay and overdrive units.
• Monologue has a X/Y matrix pad for additional realtime modu-
lation with access to all Monologue parameters.
Osc 1 and 2
Mix
Filter
Parameter Description
Waveform
(pop-up menu)
This is where you select the waveform: Saw, Square and
Sub for oscillator 1 and Saw, Square and Triangle for
Oscillator 2.
Coarse Sets the coarse pitch in semitones. The available range is
+/- one octave.
Fine Allows you to fine-tune the pitch in cent increments. The
available range is +/- 50 cents.
Depth Controls the pitch modulation depth for the mod source
defined in the “mod src” field. The available range is +/-
one octave.
Mod Src Defines the pitch modulation source. Available sources
are: Modwheel, Aftertouch, Pitchbend, Velocity, LFO and
Mod Env.
PWM
(OSC2 only)
Controls the pulse width of the square wave. In the cen-
ter position, pulse width is 50/50. Turning the PWM knob
clockwise or counter clockwise creates a positive or neg-
ative pulse, respectively.
Sync
(OSC2 only)
Activating the sync button synchronizes the pitch of os-
cillator 2 to the pitch of oscillator 1. When this is active,
changing or modulating the pitch of oscillator 2 will
change the tone and not the pitch. For the typical sync
sound, turn osc 1 down in the mix and use osc 2 only.
Parameter Description
Osc 1 Sets the pre-filter level for oscillator 1.
Noise Sets the pre-filter noise level.
Osc 2 Sets the pre-filter level for oscillator 2.
Parameter Description
Mode Sets the filter type. Available filter types are 24 dB Low
pass, 18dB Low pass, 12dB Low pass, 6dB Low pass,
12dB Band pass and 12dB High pass.
Cutoff Sets the filter cutoff frequency. How this parameter oper-
ates is governed by the filter type.
High Pass Sets the cutoff frequency of the additional high-pass fil-
ter.
Res Changes the resonance of the multi-mode filter. Full res-
onance puts the filter into self-oscillation.
Key Track Determines the amount of key tracking applied to the fil-
ter cutoff frequency. The available range is 0 to 100%. A
range of 100% tunes the filter cutoff frequency to the
keyboards pitch 1:1.
Mod Src
(A+B)
Defines the filter modulation source. The available
sources are: Modwheel, Aftertouch, Pitchbend, Velocity,
LFO, and Mod Env.
Depth
(A+B)
Controls the filter modulation depth for the mod source
set in the “mod src” field.
Parameter Description