Plug-in Reference

25
The included effect plug-ins
Mastering – UV 22 HR (Cubase only)
The UV22 HR is a dithering plug-in, based on an advanced
algorithm developed by Apogee. For an introduction to the
concept of dithering, see the chapter “Audio Effects” in the
Operation Manunal.
The following options can be set in the UV 22 HR control
panel:
Modulation plug-ins
This section contains descriptions of the plug-ins in the
“Modulation” category.
AutoPan
This is a simple autopan effect. It can use different wave-
forms to modulate the left-right stereo position (pan), either
using tempo sync or manual modulation speed settings.
The parameters are as follows:
Option Description
Hi Try this first, it is the most “all-round” setting.
Low This applies a lower level of dither noise.
Auto black When this is activated, the dither noise is gated (muted)
during silent passages in the material.
Bit Resolution The UV22 HR supports dithering to multiple resolutions:
8, 16, 20 or 24 bits. You select the desired resolution by
clicking the corresponding button.
!
Dither should always be applied post output bus
fader.
Parameter Description
Rate If tempo sync is on, this is where you specify the base
note value for tempo-syncing the effect (1/1 to 1/32,
straight, triplet or dotted).
If tempo sync is off, the auto-pan speed can be set freely
with the Rate knob, without sync to tempo.
Tempo sync
on/off
The button below the Rate knob is used to switch tempo
sync on (the button lights up) or off.
Width Sets the depth of the Autpan effect.
Shape Sets the modulation waveform. Sine and Triangle wave-
forms are available.
Side-Chain
On/Off
A signal routed to the Side-Chain input of the effect can
control the Width parameter when this is activated. For a
description of how to set up Side-Chain routing, see the
chapter “Audio effects” in the Operation Manual.