Mackie Control and Cubase

27
Other functions
In the top right corner of Mackie Control, next to the dis-
play, you will find an LED labeled Rude Solo. This LED
lights up as soon as any channel has been soloed.
The Rude Solo LED
Function keys
You can use the function keys F1 to F8 and function key
combinations with the Shift button to access functions in
Cubase. Refer to the Cubase operation manual for infor-
mation about how to assign program functions to remote
controller function keys.
On the rear panel of Mackie Control you will find two input
jacks for foot pedals, labeled User Switch A and B.
The switches and inputs on the rear panel of Mackie Control
The procedure for assigning functions to these foot ped-
als is the same as for the function keys (see above).
Cursor keys
Pressing the cursor keys located to the left of the jog
wheel is the same as pressing the arrow keys on your
computer keyboard.
Showing level meters in the
parameter display
You can show level meters for each channel in the para-
meter display. This is done by pressing Shift and the
SMPTE/Beats button. Pressing the same buttons again
reverts the display back to parameter mode.