Specifications

The Controls and Connectors
Operation Manual
17
ENGLISH
■ Transport section
This section enables you to control the transport
functions on Cubase.
1 [] (Previous) button
Moves the current position to the previous marker (or
the beginning of the project if there is no previous
marker.
2 [] (Rewind) button
Rewind.
3 [] (Forward) button
Forward.
4 [] (Next) button
Moves the current position to the next marker.
5 [] (Cycle) button
Turns Cycle mode on and off.
6 [] (Stop) button
Stops the project playback.
7 [] (Play) button
Plays back the project.
8 [] (Record) button
Records the track(s) of which the Record Enable but-
ton is turned on.
NOTE
·You can control various functions such as the trans-
port section on Cubase with your foot (for example,
for punch-in recording ease) by connecting a foot-
switch to the FOOT SW jack on the rear panel. For
information about instructions on assigning the func-
tion to the footswitch, refer to “When “User Assign-
able” is selected:” on page 18.
■ Function section
This section lets you control the Control Room Mixer
function and other functions on Cubase by assigning
the desired functions to each of these buttons and
knob. The following function sets are available.
Studio Control:
When this is selected, the Function section adjusts
the studio level of the Control Room mixer. For
details, see the next page.
Monitor Control:
When this is selected, the Function section adjusts
the monitor level of the Control room mixer. For
details, see the next page.
User Assignable:
When this is selected, you can assign desired
parameters to the buttons and knob in the Function
section. For information about instructions on assign-
ing the parameter, refer to page 18.
NOTE
· If you are using Cubase AI 4, which does not feature
the Control Room function, only “User Assignable
Function” is available from the above three function
sets.
The Function sets can be selected from the Device
Setup window (called up via [Device Setup...] under
the [Devices] menu) on Cubase. From this window,
select “Steinberg CC121” under “Remote Devices”
in the Devices box then select the desired Function
set at the “Bank” column at the bottom right corner of
the window.
1
2
3
67
5
4
8
[] (Previous) button [] (Cycle) button
[] (Forward) button [] (Play) button
[] (Rewind) button
[] (Next) button
[] (Stop) button
[] (Record) button
1
2