operation manual

ManualsBrandsSteinbach ManualsGarden & LeisureSand filter system Speed Clean Comfort 75

Sandfilter Speedclean 75/50 | 2015_V1

Page 11 of 64

Troubleshooting

Malfunction

Cause

Solution

Pressure

gauge has

reading over 1

bar

Dirty filter bed

Backwash the filter (posi-

tion 4)

Pressure is too

low

Hair and lint strainer

basket is dirty; Pump

gets too little water

Clean the hair and lint

strainer; check the suction

line and the water level

Air in the pump

Poor seal on the in-

take side of the

pump.

Tighten hose clamps and

connecting fittings.

Leaking filter

Seal Defective

Check the seal, replace if

needed

Pump does not

run

Not plugged in

Check the socket and

power cord

G.F.C.I/ or main cir-

cuit breaker tripped

Switch on the breaker (if it

is immediately tripped

again, there is a defect in

pump or controls)

Pump motor defecti-

Replace the entire pump

Sand in Pool

If the sand is newly

replaced, the under-

sized grains are still

present

Backwash several times

until the backwash water

is clear (position 4)

Sand in Central

Valve (from back-

wash)

Purge into drainpipe for

30 seconds (position 6)

Separation wall in fil-

ter is improperly in-

stalled

Check the separation wall

for proper positioning

Filter bottom strainer

is damaged

Replace the filter bottom

strainer

Air in system

Loosen, but do not re-

move, the transparency

cover on the filter tank to

allow any trapped air to

escape. Tighten the cover

once all of the air has es-

caped

Important note:

On the pump label of your filter pump is a serial number (B/...) indi-

cated and on the tank cover is a lot number shown (read from above

on handle), please provide this data in the case of a complaint.

Steinbach VertriebsgmbH,

Aistingerstrasse 2, 4311 Schwertberg, Österreich

FR/IT/CZ/HU/HR/SK/SLO/RO/BG/TR: +43 (0) 7262 / 61431-0

e-mail: service@steinbach.at