Datasheet
99
STEGO - PRODUCT CATALOGUE ACCESSORIES
TECHNICAL DATA
Mounting PG 29 thread with union nut
Torque 5 Nm
Material plastic according to UL94 V-0, light grey
weather proof and UV light resistant according to UL746C (f1)
Sealing sealing gasket NBR
Air interface approx. 1.5 cm²
Dimensions Ø 65.5 x 30.5 mm
Fitting position vertical¹
Operating/Storage temperature -45 to +70 °C (-49 to +158 °F)
Approvals EAC
¹ Protection type is restricted to IP54 if fitting position of DA 084 is not vertical.
PRESSURE COMPENSATION DEVICE
DA 084 | IP55
Installation: Make cut-out Ø 37
+1
mm in enclosure wall and mount pressure compensation device with nut. Please make sure that
the sealing gasket is put in place on the outer side panel of the enclosure. For optimal pressure compensation we recommend to
use two devices on opposite sides towards the top of the enclosure.
It has become more and more important to provide a protected enclosure environment for valuable and crucial
electrical and electronic components. In a tightly closed enclosure, pressure differentials can occur during extreme
temperature variations. The specially designed pressure compensation device DA 084 permits a controlled change
in pressure and avoids the enterring of dust and water. The pressure compensation device is suitable for the use
in enclosures and housings in accordance with DIN EN 62208.
> High degree of protection > Easy to install
Photo: Inside view
Art. No. Protection type 1 packing unit Weight (approx.)
08400.0-03 IP55 2 pieces 62 g (31 g / piece)
04.04.2017 | Specifications are subject to change without notice. Errors and omissions excepted. Suitability of this product for its intended use and any associated risks must be determined by the end customer/buyer in its final application.
www.stego.de | www.stego.co.uk | www.stegonorden.se
99
TECHNICAL DATASHEET