User guide

SPECIALTY APPLICATION WIRING DIAGRAM
(six pole configuration utilizing power line carrier signal and an
auxiliary control device)
This Device MUST be Grounded.
Grounding and Bonding is not shown in this Diagram.
Optional Auxiliary Control
In This Example, Circuits 4,5,&6
are Controlled by PLC Signal Only
Auxiliary Control.
CIRCUIT 6
CONTROLLED LOAD
CIRCUIT 5
CONTROLLED LOAD
CONTROLLED LOAD
CIRCUIT 3
CONTROLLED LOAD
CIRCUIT 2
CONTROLLED LOAD
CIRCUIT 4
CIRCUIT 1
CONTROLLED LOAD
and by an Optional
Controlled by PLC Signal
Circuits 1, 2, and 3 are
In This Example,
CR6
CR4
COM
CR1
CR2 CR3
CR5
L2L2T1
CIRCUIT 5 CIRCUIT 6
T1T1L2L2
CIRCUIT 2
T1
CIRCUIT 3
T1L1
CIRCUIT 1
T1 L2
120 240 L1
CTS 206-8
3
O
N
21 65 7 84
9504
109
CIRCUIT 4
L2
(i.e. room thermostat)
Low Voltage
Terminal Strip
IMPORTANT
w The equipment described herein is intended for installation by a
qualified technician in accordance with applicable local, state, and
national codes and requirements.
w This manual should be retained by the owner upon completion of the
installation and made available to service personnel as required.
w Disclaimer:
 Conditions may occur which cause the power line carrier
transmitter and receivers to have difficulties communicating;
therefore, not operating properly. In no event shall Steffes
Corporation be liable for any indirect, special, or consequential
damages or lost profits.
 In compiling this manual, Steffes Corporation has used its best
judgement based upon information available, but disclaims any
responsibility or liability for any errors or miscalculations
contained herein, or any revisions hereof, or which result, in
whole or in part, from the use of this manual or any revisions
hereof.
WARNING
HAZARDOUS VOLTAGE: Risk of electric shock, injury, or
death. System may be connected to more than one branch
circuit. Disconnect power to all circuits before servicing.
Equipment must be installed and serviced by a qualified
technician.
FOR CUSTOMER USE
Please record the serial number of the mini receiver below. This information
is located inside the mini receiver enclosure. Retain this information for
future reference.
Serial No.________________________________________________
9