User's Manual

• Enter the vehicle and turn the key to Acc position. The siren will chirp sharply.
• Press the foot brake and press override reset switch 5 times continuously, the control unit will send the signal
to LED light and siren. The LED light will turn on and the siren will stop alarming and enter the disarm mode.
You can now start and operate the vehicle normally. Press the button
to recover the system. (It is highly
recommended to hide this override switch in a position only known to you.
22. Disable the former remote
Press the learning button in the control unit for 10 seconds to cancel the former remotes.
23. Code learning
Press the learning button in the control box for 2 seconds, the LED light turns on, the press the
button in both remote in
10 seconds. The two new remote are
OK
Only two remote controllers are functional for car alarm system with code hopping function, the lost remote controller will
not operate the system again.
EMITTER FUNCTION AND OPERATION FOR MODEL 888 CAR ALARM SYSTEM:
FCC/ID Q6W888
FCC NOTICE:
(b) For a Class B digital device or peripheral, the instructions furnished the user shall include the following or similar statement,
placed in a prominent location in the text of the manual:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the