Use and Care Manual

-6-
ST1010 6" Jointer (Mfd. Since 3/16)
Controls &
Components
Refer to Figures 1–3 and the following descriptions
to become familiar with the basic controls and com-
ponents of this machine. Understanding these items
and how they work will help you understand the
rest of the manual and stay safe when operating this
machine.
ON/OFF Switch: Starts and stops the motor. The
switch can be disabled to prevent unauthorized use
by removing disabling key.
Power Indicator Light: Illuminates when machine is
plugged into power.
Depth Scale: Indicates depth of cut.
Infeed Table Adjustment Lever: Adjusts position of
infeed table, which controls depth of cut.
Outfeed Table Handwheel: Adjusts position of
outfeed table. Only used when setting outfeed table
even with cutterhead knives.
Figure 1. Pedestal-mounted controls.
Power
Indicator
Light
ON/OFF
Switch
Figure 2. Table movement controls.
Infeed Table Lever
Depth Scale
Outfeed Table
Handwheel
Figure 3. Fence movement controls.
Fence
Lock
90° Fence
Stop
45° Fence
Stop
Fence
Adjustment
Knob
Tilt
Lock
Fence Adjustment Knob: Rotates to adjust lateral
position of fence along width of tables.
Tilt Lock: Secures fence tilt setting at desire angle.
45° Fence Stop: Stops fence at 45° inward and 45°
degree outward (135°).
Note: Even when fence is resting against stops, tilt lock
must be tightened before starting machine.
90° Fence Stop: Stops fence at 90° when engaged.
Note: Even when fence is resting against stops, tilt lock
must be tightened before starting machine.
Fence Lock: Tightens to secure fence position along
width of tables; loosens to allow adjustment.