Use and Care Manual

ST1010 6" Jointer (Mfd. Since 3/16)
-27-
Squaring Stock
Squaring stock involves four steps performed in the
order below:
1. Surface Plane On The Jointer: The concave
face of the workpiece is surface planed flat with
the jointer (see Figure 37).
Figure 37. Surface plane on the jointer.
Figure 38. Surface plane on a thickness planer.
Previously Surface
Planed Face
2. Surface Plane On a Thickness Planer: The
opposite face of the workpiece is surface planed
flat with a thickness planer (see Figure 38).
3. Edge Joint On The Jointer: The concave edge
of the workpiece is jointed flat with the jointer
(see Figure 39).
Figure 39. Edge joint on the jointer.
Previously Jointed
Edge
Figure 40. Rip-cut on a table saw.
15
30
45
4. Rip-Cut On A Table Saw: The jointed edge of
the workpiece is placed against a table saw
fence and the opposite edge cut off (see
Figure 40).