Use and Care Manual

-26-

ST1010 6" Jointer (Mfd. Since 3/16)

Infeed Table

Adjustment

Figure 36. Adjusting infeed table height.

Proper infeed table adjustment must be made to

safely and efficiently use the jointer. DO NOT set the

infeed table depth greater than

⁄8", unless rabbeting.

To adjust the infeed table:

1. Loosen the infeed table lock in Figure 35.

Figure 35. Infeed table lock.

Table Stop Lock Nuts

Infeed Table

Lock

2. Use the infeed table lever to raise or lower the

infeed table (see Figure 36).

3. Use the depth of cut scale to set the infeed

table to the desired depth and lock the table in

position.

Note: The infeed table stops can be adjusted to

return the table height to the same height every

time by loosening the lock nuts and adjusting the

set screws.

Kickback can occur if excessive depth of cut

is made. Limit a single pass to

⁄8". Serious

personal injury could occur in the event of a

kickback.