Use and Care Manual
ST1010 6" Jointer (Mfd. Since 3/16)
-23-
Test Run
Once assembly is complete, test run the machine to
ensure it is properly connected to power and safety
components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem
BEFORE
operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding setup
instructions have been performed. Operating
an improperly set up machine may result in
malfunction or unexpected results that can
lead to serious injury, death, or machine/prop-
erty damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation,
then turn machine OFF. The motor should run
smoothly and without unusual noises.
Figure 31. Removing switch key from paddle switch.
5. Try to start machine with paddle switch.
— If machine does not start, the switch disabling
feature is working as designed.
— If machine does start, immediately stop the
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
4. Remove switch disabling key (see Figure 31).
Recommended
Adjustments
For your convenience, the adjustments listed below
have been performed at the factory and no further
setup is required to operate your machine.
However, because of the many variables involved
with shipping, we recommend that you at least verify
the following adjustments to ensure the best possi-
ble results from your new machine.
Step-by-step instructions for these adjustments can
be found in SERVICE.
Factory adjustments that should be verified:
1. Knife Settings (Page 37).
2. Depth Scale Calibration (Page 38).
3. Fence Stop Accuracy (Page 39).