Use and Care Manual

-22-
ST1010 6" Jointer (Mfd. Since 3/16)
Setting Outfeed Table
Height
The outfeed table must be level with the knives
when they are at top-dead-center. This adjustment
has been made at the factory but should be checked
again before operating your jointer. This adjustment
will also have to be made any time you perform main-
tenance on the cutterhead or knives.
To set the outfeed table height:
36. Place a straightedge on the outfeed table so it
extends over the cutterhead.
37. Rotate cutterhead pulley until one of the knives
is at top-dead-center (TDC), (see Figure 28).
Top Dead
Center
Figure 28. Cutterhead knife at top-dead-center.
Straightedge
Outfeed Infeed
Figure 29. Using a straightedge to align outfeed
table height with knife at TDC.
38. Raise or lower the outfeed table until the knife
just touches the straightedge (see Figure 29).
Figure 30. Outfeed table lock.
4. Lock the outfeed table in position (see Figure
30).