Use and Care Manual

ST1010 6" Jointer (Mfd. Since 3/16)
-21-
30. Install the support arm with (2) M8-1.25 x 40 cap
screws, hex nuts, (2) 8mm flat washers, and (2)
8mm lock washers as shown in Figure 24.
Figure 25. Cord locations.
Motor Cord
Power Cord
Hold Downs
Figure 24. Installing support arm.
31. Plug the motor cord into the back of the switch
box, then secure the loose cords with two hold
downs and (2) M5-.8 x 12 Phillips head screws as
shown in Figure 25.
33. Secure the handwheel (see Figure 26) to the
shaft with the hardware removed in Step 1.
Figure 26. Securing the handwheel.
34. Thread the infeed table lever into the hole
shown in Figure 27.
Figure 27. Installing infeed table lever.
35. Tighten the locknut.
32. Remove the Phillips head screw and flat washer
already mounted to the handwheel shaft.