Use and Care Manual

ST1010 6" Jointer (Mfd. Since 3/16)
-19-
Figure 16. Assembled carriage mounting bracket.
20. Tighten carriage mounting bracket to the jointer
table with (4) M8-1.25 x 60 cap screws, (4) 8mm
lock washers, and (4) 8mm flat washers (see
Figure 16).
21. Use two M8-1.25 x 20 cap screws, lock washers,
and flat washers to secure the fence carriage
assembly to the carriage mounting bracket (see
Figure 17).
Figure 17. Fence carriage assembly.
22. Use (2) M8-1.25 x 25 cap screws, (2) 8mm lock
washers, and (2) 8mm flat washers to secure the
fence assembly to the fence carriage assembly
(see Figure 18).
Figure 18. Installing fence assembly.
Figure 19. Installing fence tilting handles.
23. Thread the fence tilting handles into the fence
(see Figure 19).
Figure 20. Cutterhead guard set screw location.
24. Remove the set screw in the cutterhead guard
shaft (see Figure 20).
The cutterhead guard is a critical safety feature
on this machine. A torsion spring is mounted
on the cutterhead guard shaft to help it return
to its proper position over the cutterhead after
a cutting operation. This torsion spring must
have spring pressure during guard installation
to work properly.