Use and Care Manual

-18-
ST1010 6" Jointer (Mfd. Since 3/16)
11. Secure the jointer to the cabinet with the (3)
M10-1.5 x 20 cap screws, (3) 10mm flat washers,
and (3) M10-1.5 lock washers.
Note: To access forward mounting hole, reach
through the dust vent for access to the forward
mounting hole as shown in Figure 12.
— If the pulleys are aligned, tighten the motor
mounts loosened in Step 1 and go to Step 7.
— If pulleys are NOT aligned, do Steps 5 & 6.
Figure 14. Pulleys should be parallel and aligned.
Alignment
Setscrew
Motor Pulley
Motor
Cutterhead
Pulley
Cutterhead
16. Remove the V-belt, loosen the set screws on the
end of the motor pulley, and use a straightedge
to align the motor pulley with the cutterhead
pulley. If needed, the motor can be loosened
and moved in or out to bring the motor pulley
into alignment with the cutterhead pulley.
17. Tighten the set screws, replace the V-belt, and
repeat Step 4. The pulleys should be perfectly
parallel and aligned, as shown in Figure 14.
18. Replace the access cover on the cabinet.
19. Align the locating pins on the back of the car-
riage mounting bracket with the sockets on the
jointer table (see Figure 15).
Figure 15. Locating pins.
Locating Pins
Sockets
Figure 12. Installing forward mounting bolt.
12. Using a 13mm wrench, loosen the motor mount
bolts, but DO NOT remove them.
13. Lift the motor upward far enough to place the
V-belt around the cutterhead pulley and the
motor pulley as shown in Figure 13.
Figure 13. Installing V-belt on cutterhead pulley.
14. Carefully allow the motor to slide downward,
tensioning the V-belt with the weight of the
motor.
15. Looking from the top, sight down the V-belt and
pulleys and check to see that the pulleys are
parallel and aligned with each other (see Figure
14).