Use and Care Manual

ST1010 6" Jointer (Mfd. Since 3/16)
-17-
Assembly
1. Lay the cabinet on its side and install the level-
ing feet as shown in Figure 8.
Figure 8. Installing the leveling feet.
Leveling
Feet
Figure 9. Installing locking foot pedal.
2. Place the locking foot pedal assembly onto the
cross brace at the bottom of the cabinet.
3. Use a 14mm wrench to install the M8-1.25 x
50mm hex bolt and flat washer as shown in
Figure 9.
Note: The hex bolt installs from inside motor
cabinet.
4. Use a 17mm wrench to install the two M10-1.5 x
55 hex bolts, flat washers, and hex nuts through
the front of the locking foot pedal assembly as
shown in Figure 10.
Figure 10. Installing locking foot pedal.
5. Raise the cabinet upright.
6. Lock the foot pedal down.
7. Level the cabinet front-to-back and side-to-side
by adjusting the leveling feet.
8. Remove the access cover on the cabinet.
9. With the help of an assistant, lift the jointer onto
the cabinet.
10. Align the three mounting bolt holes on the
jointer with the three holes on the cabinet (see
Figure 11).
Figure 11. Mounting holes.
Mounting Holes
To assemble jointer: