Manual

Owner's Manual
OPERATINGYOUR MOWER
Fig. 11
Fig.12
1
\
NOTE: Be sure to replace the parts in the exact order in which they were removed. When installing the cutting blade,
verify that it is installed with the curved ends pointing toward the mower deck.
CLEAN THE MOWER
WARNING: To reduce the risk of electric shock, do not expose the mower to water.
The underside of mower deck should be cleaned after each use as grass clippings, leaves, dirt and other debris will
accumulate causing rust and corrosion.
Remove any buildup of grass and leaves on or around the motor cover (do not use water). Wipe the mower clean with a
dry cloth occasionally.
• If debris build up on the underside of the unit while using, stop the motor and disconnect it from the power supply. Tilt the
mower forward, or on its side, and scrape it clean with an appropriate toot.
STORAGE
The following steps should be taken to prepare the lawn mower for storage.
• Make certain the power cord is disconnected.
• Clean mower as instructed in previous section.
• Inspect and replace/sharpen blade, if required. Refer to the Maintenance section.
° Store mower in a dry, clean area. Do not store next to corrosive materials, such as fertilizer and rock salt.
• Wipe extension cord to remove any foreign substances such as oil or stains. Replace extension cord if cut or damaged
in any way.
• Wind cord in a series of equal loops to prevent it from tangling.
• Store mower indoors, in a cool, dry place, out of the reach of children. Do not cover lawn mower with a solid plastic sheet.
Plastic coverings trap moisture around the mower causing corrosion.
The handle may be folded away completely for storage.
• Loosen the handle knobs on the sides of the handle, and fold the upper handle down.
• Loosen the handle knobs, pull outwards on each side of the lower handle, and lift the sides of the lower handle past the
edges of the handle mounting brackets. Fold the lower handle f_vard. Make sure not to bend or kink the power cord.