Manual

Owner's Manual
OPERATINGYOUR MOWER
CHARGING PROCEDURE
Note: The battery can be chargedin or out of the mower.
Thecharger that is supplied with this mower is a specially designed 2=stagecharger.
Step 1: The red light will light up during the recharge cycle.
Step 2: The green light will light up when the battery is fully charged.
1. Remove the jack cover.
2. Plug the charger connector into the jack on the battery.
3. insert the 120 V plug from the charger into the electrical outlet.
4. The red light on the charger should come on, which indicates that the charger isworking and the
battery is being charged.The redlight will go out andthe green light will come on when the battery
is completely charged (it takes approximately 15 hours to charge a fully discharged battery).
©
(9
INSTALLINGBATTERY
!
Push battery down Laminated both
to limit chute after rotaing
Level b,vo rails Slide into the
pole position
REMOVINGBATTERY
Pull up the Rotation and bring lift battery
battery pack
_e n Figure
t,
_, WARNING:Do not store battery in temperatureslower than 32°F (O°C)
BATTERYUSE
NOTE:if the switch does not reengageor the mower does not run
when the battery is installed.
Push the Battery Capacity indicator (BCi) switch, which is located on
the back of the battery. Thelights will indicate the battery's capacity,
according the following chart.
00000 )
Green Green Green Yellow Red BCIswitch
IB_ 13_ E3_ IC3PEC3_
Lights capacity
3 Green Lights The battery is atfull capacity
2 Green Lights The battery is at 60% capacity
1 Green Light The battery is at 50% capacity
Yellow Light The battery is at 40% capacity and
requires charging soon
Red Light The battery is at 20% capacity and
requires charging