Owner's Manual // awlli 5P-PHI35fi tons_vlcE CALL: 888-8S5-5881 PARA 5ERVICIO LLAME:
Introduction Do not tamper with the engine controls or alter the governor speed; doing so may create an unsafe condition resulting in personal injury. This rotary-blade, walk-behind lawn mower is intended to be used by residential homeowners or professional, hired operators. It is designed primarily for cutting grass on well -maintained lawns on residential or commercial properties. It is not designed for cutting brush or for agricultural uses.
o Do not operate • Never store the machine or fuel container machine while under the of aUcohomor where there is an open flame, spark, or pilot light such as on a water heater or on other appliances. Never fill containers inside a vehicle or on a truck or , Never operate mower in wet grass. Always be sure of your footing; walk; never run. o Disengage the drive system, if so equipped, before starting the engine.
1. Remove Product specification Component impoAant: Route the cables to the outside the handle as you install the handle. specification _ Rated power the handle knobs from the mower housing 3600w/5HP of Rated sPeed ............................................................... Displacement _ t40cc Cutting width 1.5" to 3" (3 Positions) Wheels 7"and12" 30kg Safe_ lmpo_ant: and instructional Decals Safety and instruction areas of potential danger, Replace I, HandLe knob (2) 2.
Product Overview Impo_ant:To reduce starting problems, add fuel stabiiizer to the fuel all season, mixing it with gasoline less than 30 days old. 2 Figure 5 Checking the Engine 3 Figure 4 1. Air filter 3. Oil filltdispstick 5. Knob Attach Oil Level Service lnter,_ah Before each use or daily 1. Remove the dipstick, wipe it clean, and fully install the dipstick (Figure 6). 2. Fuel tank cap 4.
Adjusting the Cutting Height Adjusting the cutting height may bring you into contact with the moving blade, causing sedous injury. ° Stop the engine and wait for all moving pads to stop. * Do not put your fingers under the housing when adjusting the cutting height. Figure 8 If the engine has been running, the muffler will be hot and can severely burn you. Keep away from the hot muffler. Adjust the cutting height as desired. to the same height.
Operating Tips Mulching the Clippings Your mower comes from the factow ready to mulch the grass and leaf clippings back into the lawn.if the grass bag is on the mower, remove it (refer to Removing Grass Bag) before mulching the clippings. Bagging the Clippings General Mowing Tips , Clear the area of sticks, stones, wire, branches, other debris that the blade could hit. the (Not Included) , Avoid striking solid objects with the blade. Never deliberately mow over any object.
Cutting Leaves • After cutting the lawn, ensure that half of the lawn shows through the cut leaf cover. You may need to make more than one pass over the leaves. • if there are more than 5 inches (13 cm) of leaves on the lawn, set the front cutting height one or two notches higher than the rear cutting height. ° Slow down your mowing speed if the mower does not cut the leaves finely enough.
Replacing 3. Tip the mower onto its side, with the dipstick to drain the used oil out through the oil fill tube (Figure 15). the Air Filter Service interval:Every 25 hours 1. Use a screw driver to open the air filter cover (Figure down, 12). Figure15 Figure 2. Replace 12 the air filter (Figure 13). 4.Slowly pour oil into the oil fill tube unlLil the oil level reaches the Full line on the dipstick (Figure 15). Do not overfill (Max. fiH :20 oz. (0.
2.Whennomoreclippingscomeout,stopthewater andmovethe mowerto a dry area. 3. Runthe enginefor a few minutesto dry the housing to preventit fromrusting. 5. Installthe newblade(turnthe bladeboltclockwise) andall mountinghardware(Figure16). Storethe mowerin a cool,clean,dry place. Preparing the Mower for Storage Gasoline vapors can expJode. o Do not store gasoJine more than 30 days. * Do not store the mower in an encJosure near an open name. , AHow the engine to cooJ before storing it. 1.
1, Handle knob 2, Move the handle forward Removing Figure Connect 18 Figure 10 19 the Mower as shown in Figure from the wire to the spark ptug. Storage 18.
