Installation Instructions

Floating Surface Adjustable Bracket Installation Guide & Warranty Information 4
Option 1A: Mounting Bracket to Back or Side of Cabinet
1 – Attach ¾” plywood (if necessary) to inside of cabinet to meet 3/4”
min. wall thickness requirement. Attach using four wood screws
(not included).
2 – Notch top wall ¼” by 2 ⅛”. Cut ¼” radius on inside wall. If mounting
to side of cabinet, use a jigsaw to cut a slot at least ½" by 2 ⅛" in
any support that obstructs the bracket’s t.
3 – Using bracket as a template, mark and drill ⅛” pilot holes ½” deep.
4 – Make sure bracket ts tightly on wall surface and there is
1
⁄
16
″ gap
(very important) from top of bracket to top of wall. If not, remove
material in notch or radius.
5 – Attach bracket to wall using 2 - ¾” wood screws, one in bottom
hole and one in middle hole.
6 – Go to page “Adjusting Set Screws and Installing Countertop.”
Mounting Options continued
Mounting to Back of Cabinet Mounting to Side of Cabinet
➋
➌
➋
➎