Instructions / Assembly

ManualsBrandsSteel Core ManualsPower Tool Accessories96 in. Folding Miter Saw Work Stand with Quick Mounts

customerservice@focus-ontools.com

1-800-348-5004

SPECIFICATIONS

CONGRATULATIONS

PARTS

You have just purchased a Folding Miter Saw Stand. This product has been specifically

designed to assist you in the use of most miter saws.

Max. Weight Capacity

Table Height

Table Width

Stand Width (Max. Extended

Stand Weight

331. lbs.

34 in.

39-1/8 in.

96 in.

24 lbs.

Summary of content (4 pages)

PAGE 1
SPECIFICATIONS Max. Weight Capacity 331. lbs. Table Height 34 in. Table Width 39-1/8 in. Stand Width (Max. Extended 96 in. Stand Weight 24 lbs. CONGRATULATIONS You have just purchased a Folding Miter Saw Stand. This product has been specifically designed to assist you in the use of most miter saws. PARTS customerservice@focus-ontools.
PAGE 2
#3040 GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS Using power tools of any kind can be dangerous if safe operating procedures are not followed. Recognizing the hazards of each tool and using them with respect and caution will considerably limit the possibility of personal injury. However, if safety precautions are ignored, personal injury will likely result. Always use common sense – your personal safety-is your responsibility. Know your power tool.
PAGE 3
ASSEMBLY INSTRUCTIONS Read all assembly instructions completely before attempting assembly. See parts list on Page 2 for names and pictures of parts. Identify all components and hardware. Figure 1 1. Install Leg as shown in Figure 1 to Top Frame and secure with and 1/4" Lock Nut . Insure that Snap Pin is 1/4" - 20 x 1-3/4" Bolt facing out and securely latches in the open and closed positions. Do not over tighten. Repeat on remaining three Legs.
PAGE 4
9. Carefully lift the saw and place onto the miter saw stand. Be sure the hook end of the machine mount locks under the top tube as shown in Figure 7. The spring loaded handle should lock under the opposite top tube as shown in Figure 8. 10. Slide the saw forward or back along the machine mount to best balance the saw on the stand. Secure the saw by tightening the carriage bolts Figure 6 installed in Step 8. Figure 7 SET-UP / KNOCKDOWN PROCEDURE 1. Remove the saw from the work stand. OPEN 2.