Use and Care Manual

[e-mail]
2
1-800-348-5004
READ CAREFULLY BEFORE USE
SPECIFICATIONS
• Drill Capacity: 3/8”
• Free Speed: 1,500 RPM
• Spindle Thread: 3/8”
• Required Air Pressure: 90 PSI
• Average Air Consumption: 4.0 CFM
• Air Inlet: 1/4” NPT
BEFORE EACH USE
1. Drain water from air compressor tank and condensation from air lines.
(Please refer to air compressor’s operation manual.)
2. Lubricate the tool. (Please refer to the “Maintenance” section in the manual.)
3. Connect air drill to air source with the hose of recommended size.
OPERATION
1. Turn on the air compressor and allow its tank to be filled.
2. Set the air compressor regulator to 90 PSI. This air drill operates at a maximum of 90 PSI
air pressure.
3. Depress the trigger to start operating the tool.
4. Release the trigger in order to stop the tool.
5. When changing parts, always disconnect air supply to avoid injury.
6. When job is completed, turn off the air compressor and store the air tool after lubrication.
GENERAL SAFETY GUIDELINES
This product is a part of high pressure system and the following safety precautions must be followed
at all time along with any other existing safety rules.
1. Read all manuals included with this product carefully. Be thoroughly familiar with the controls and
the proper use of the equipment.
2. Only persons well acquainted with these rules of safe operation should be allowed to use the air tool.
3. Do not exceed any pressure rating of any component in the system.
DANGER: DO NOT exceed the maximum operating pressure of the air tool (90 PSI.) The air tool
could explode and result in death or serious injury.
4. Disconnect the air tool from air supply before changing tools or attachments and during non-operation.
5. Always wear safety glasses and ear protection during operation.
WARNING: Always wear ANSI approved Z87.1 safety glasses with shields.
WARNING: Always wear ANSI S3.19 hearing protection.
6. Do not wear loose fitting clothing or apparel which contains loose straps or ties, etc. which
could become entangled in moving parts of the tool and results in serious personal injury.
7. Do not wear jewelry, watches, identifications, bracelets, necklace, etc. when operating any tool,
they may become caught in moving parts and result in serious injury.
8. Do not depress trigger when connecting the air supply hose.
WARNING: DO NOT use hand tool sockets. Use impact quality sockets only.