Use and Care Manual

Procedures not specifically explained in this manual must be performed only
by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn off the tool, detach the air supply, safely discharge any residual air pressure
in the tool, and release the throttle before performing any inspection, maintenance,
or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise, vibration,
or leaking air occurs, have the problem corrected before further use.
Note: These procedures are in addition to the regular checks and maintenance explained
as part of the regular operation of the air-operated tool.
1. Daily - Air Supply Maintenance:
Every day, maintain the air supply according to the component manufacturers' instructions.
Maintain the lubricator's oil level. Drain the moisture filter regularly.
Performing routine air supply maintenance will allow the tool to operate more safely and
will also reduce wear on the tool.
2. After each use, wipe off the tool, clean out any accumulated saw dust, and replace the
sandpaper as needed.
3. If the Trigger begins to stick, apply a few drops of oil and pump the Trigger to distribute
the oil.
TO PREVENT SEROUS INJURY FROM EXPLOSION:
Lubricate the tool only with specified lubricants. Lubricate the air inlet using
only pneumatic tool oil. Lubricate the internal mechanism using only white
lithium grease. Other lubricants may damage the mechanism and may be
highly flammable, causing an explosion.
USER-MAINTENANCE INSTRUCTIONS
CLEANING, MAINTENANCE, AND LUBRICATION
1-800-348-5004
[e-mail]
13