Use and Care Manual

OPERATING INSTRUCTIONS
TOOL SET UP
1-800-348-5004
[e-mail]
11
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn off the tool, detach the air supply, safely discharge any residual air pressure
in the tool, and release the throttle and/or turn the switch to its off position before
performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or component in a way not specifically explained within
this manual. Improper adjustment can result in tool failure or other serious hazards.
)31 egap no tsiL yrosseccA ees ,yletarapes dlos( repapdnas fo spirts ″2/1-71 x ″4/3-2
are used with this Inline Sander. The sandpaper is held in place at each
end of the Sander with a toothed clamp and tension bar.
Tension bar
Clamp
Clamp
Tension bar
Figure C
To install the sandpaper:
Raise
Tension bar
Figure D
1. Pull up on the tension bar at
each end of the Sander.
Sandpaper
Screwdriver
Teeth
Lower
Tension bar
Figure E
2. Center the Sander over the back side
of the sandpaper. Slide one end of the
Sandpaper under the teeth. Hold in place
with a screwdriver (sold separately) and
lower the tension bar to secure the end.
3. Check that the sandpaper is aligned along
the length of the sanding pad and slide
the sandpaper under the teeth at the other
end of the Sander, pushing the Sander
towards the clamped end to make sure the
sandpaper is taut. Hold in place with the
screwdriver and lower the tension bar.
To remove the sandpaper:
Pull up on the tension bar at each end of the
Inline Sander and pull out the sandpaper.