Use and Care Manual

TO PREVENT SERIOUS INJURY: Operation of a puller involves more than pulling the lever.
The use of pullers is subject to certain hazards that cannot be met by mechanical means,
but only by the exercise of intelligence, care, common sense, and experience in anticipating
the motions that will occur as a result of operating the controls.
Do not use this tool for vertical lifting.
[e-mail]
3
1-800-348-5004
SPECIFICATIONS
SETUP INSTRUCTIONS
1. The supporting structure the puller is mounted to
(including trolley, monorail, or crane) must be
designed to withstand the loads and forces
imposed by the puller for the rated load.
2. Properly seat the anchor hook on the supporting
structure at its intended load bearing point
(see the left side diagram of Figure A).
Do not allow the hook hitch to support any part of the load.
Do not apply the load to the point of the hook
(shown in Figure A on the right side diagram).
1. Familiarize yourself with all operating controls of the puller and with the operation(s) to be
performed. Instructions include, the warnings on the puller, and the safety and operating
instructions portion of this manual.
2. WARNING! TO PREVENT SERIOUS INJURY FROM PULLER FAILURE:
Do not use damaged equipment.
If adjustments or repairs are necessary, or any defects are known, have the problem
corrected before further use.
3. Do not operate a puller with an out-of-order sign.
4. Only a qualified technician should perform maintenance to the puller.
Note: For additional information regarding the parts listed in the following pages, refer to Parts List
and Diagram on page 9.
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
OPERATION INSTRUCTIONS
BEFORE OPERATING PULLER
Rated Capacity
Item No. 36700
4,000 lb.
Cable Length 10’
Figure A: Correct and incorrect
anchor hook attachment
Rated Capacity
Item No. 36701
8,000 lb.
Cable Length 12’