Full Product Manual

[e-mail]
4
1-800-348-5004
5. Do not use the wire rope as a ground for welding. Do not touch a welding electrode to the wire rope.
6. Designate a work area that is clean and well-lit. The work area must not allow access by children
or pets to prevent distraction and injury.
7. There must not be objects, such as utility lines, nearby that will present a hazard while working.
8. Inspect the puller as explained in Frequent Inspection on page 8 after setup but before use.
1. Swing the Handle away from the Anchor Hook to expose the Drive Pawl.
2. Slide the Pawl Spring up to the disengaged position. The Drive Pawl will be held clear of the
Ratchet (Figure D).
3. Squeeze the Stop Pawl Trigger as shown below (Figure E).
4. Pull the wire rope out to reach the load.
OPERATING CONTROLS
APPLYING THE LOAD
Anchor
Hook
Pawl
Spring
Ratchet
Drive
Pawl
Lever
Stop Pawl
Trigger
(hidden)
Guard
Wire
Rope
Load
Hook
Figure B
Figure D: Drive Pawl Operation
Drive PawlRatchet
Disengaged Engaged
Pawl
Spring
Figure E: Releasing the Stop Pawl
Anchor Hook
Ratchet
Load Hook
Stop Pawl
Trigger
Stop Pawl Trigger