User manual

Table Of Contents

3. Press SET. The Delete slave dialogue appears (Fig. left).

4. Hold SET pressed for 1 s. The selected slave is deleted.

Synchronising slave

NOTICE!

– The Synchronise slave function actively transfers the parameter settings of the MPPT 6000-

M master to all MPPT 6000-S slaves.

–

StecaLink PA HS400 slaves are not synchronised. No configurable data is stored in the PA

HS400.

– Each MPPT slave executes a reset after receiving the information, in order to adopt the

new values.

– The reset interrupts charging, switches off the module and battery relays and executes a

complete restart of the device.

– Charging is started again after a restart caused by synchronising, depending on the

configuration of the slaves, see

‘Configuring the operating mode’ on page 89 and the

Device On/Off state of the master.

– The restart causes each MPPT 6000-S to perform a new system voltage detection, see

Chapter 4.4 ‘Supplying the controller with voltage’ on page 31.

– If ‘Save setting’ is set for the slave in the Configuration MPPT slave menu ,

see

‘Configuring the operating mode’ on page 89, then the settings are saved in the

MPPT 6000-S.

Synchronising

✔

‘Main menu è System settings è StecaLink master menu

è Synchronise

’

1. Press SET. The Synchronise slave dialogue appears (Fig.

left).

2. Hold SET pressed for 1 s. The transmission is started.

3. The display automatically changes to the higher-level menu.

8.9 Internal data logger

The data logger stores the following data in the internal memory:

n Energy input

n Energy output (MPPT 6000-M only)

n Min. battery voltage

n Max. battery voltage

n Max. charging current

n Max. PV 1 voltage

n Max. PV 2 voltage

756.404 | Z01 | 16.06