User manual

switches to the Float charging mode. If the battery voltage cannot be maintained at
>2.53 V/cell for longer than 120 s during the the IA phase then the IA is ended and
the sequence starts again in the I phase. If the battery voltage reaches a value >=
2.6 V/cell during the IA phase then the MPPT 6000-M switches off the charging. The
device enters the OFF
state. This ends the IUIA charging cycle.
IUIA charge mode On/Off
✔
‘Main menu è Battery settings è IUIA activation è On/Off ’
1. Press SET. The IUIA activation dialogue appears (Fig. left).
2.
Press D, Ñ to change the value.
3. Press SET. The value is adopted.
IUIA charge mode Cycle
✔
‘Main menu è Battery settings è IUIA charge mode è Cycle ’
1. Press SET. The IUIA charge cycle dialogue appears (Fig.
left).
2.
Press D, Ñ to change the value.
3. Press SET. The value stops blinking.
8.5.10 Start boost charge
NOTICE!
– Start boost charge
allows boost charging to be started manually.
– The boost charging is executed using the previously configured parameters.
– The device switches to float charging on completion of boost charging.
– This function is only available for lead-acid and lead-gel/AGM battery types.
– Once started, boost charging can only be stopped by switching the device off (OFF).
✔
‘Main menu è Battery settings è Start boost charge’
1. Press SET. The Start boost charge dialogue appears. (Fig.
left).
2. Press SET for 1 s to start the boost charge.
756.404 | Z01 | 16.06 70