User manual

n Total battery charge current (MPPT 6000-M only): Total battery
charge current of all components activated in the menu
‘Battery settings è Battery control mode
è Sensor member list’. Display of the average current in A.
1 )
"-" is displayed instead of the battery voltage when the battery
voltage sensor cable is not connected.
2)
"-" is displayed while the capacity test is running or has not yet
been executed. The result of a successfully completed capacity test is
retained until successful completion of the next capacity test. The
result of the capacity test is deleted if the device is disconnected
from the power supply.
Measurement display for additional StecaLink slave devices
①
Identifier of the StecaLink slave device.
②
StecaLink bus address of the device.
③
Device name assigned by the user.
④
Measuring position of the device.
⑤
Measured current, average value in A.
NOTICE!
The controller is not approved as a calibrated measuring device.
The displayed measurements and internally calculated values are subject to product-specific
tolerances and can therefore deviate from reference measurements made using calibrated
measuring instruments. Not all measurements and the values calculated from these are
updated in the same time frame. This can result in delayed updating of the displayed values.
Information bar
①
Date
②
Symbol for Non-confirmed event messages; see Ä Chapter
10.2 ‘Event messages’ on page 111 for more information.
③
Connect symbol with 2-digit controller address: Indicates data
traffic on the StecaLink slave bus connection.
④
Symbol for the charging function presently being executed:
E (Equal charge)
F (Float charge)
B (Boost charge)
756.404 | Z01 | 16.06 55