User manual

Measurements
①
Measurement name
②
Measurement with units
The following measurements are displayed in the same sequence as
described here:
n Charge current MPPT: The current flowing from the controller to
the battery, in Amperes.
n Battery voltage: The battery voltage measured at connection
"B+/B–", in volts (V).
n Voltage ext. bat. sense
1)
: Battery voltage measured via the
battery voltage sensor cable, in volts (V).
n SOC (MPPT 6000-M only): Charge state of the battery in %
(displayed only when the battery setting ‘Battery control mode
è State of charge (SOC)
’ is active.
n Result of capacity test (MPPT 6000-M only)
2)
: Result of a
manually started battery capacity test. Measured value displayed
in Ah.
n PV 1 voltage: Voltage present at module connection M1, in volts
(V).
n PV 2 voltage: Voltage present at module connection M2, in volts
(V).
n PV power total: Actual power being used for charging the
battery, measured at the module connections M1 and M2 , in
watts (W).
n PV power 1: Actual charging power at module connection M1,
in watts (W).
n PV power 2: Actual charging power at module connection M2,
in watts (W).
n Operating hours: Number of operating hours since initial
commissioning of the device.
n Power information from additional StecaLink slave participants
(MPPT 6000-M only): The scope and designations of the display
depend on the respective slave device and its configuration.
Observe the notes on this in
Ä Chapter 8.8 ‘StecaLink bus’
on page 85.
n Total battery charge/discharge current (MPPT 6000-M only):
Total current of all components activated in the menu
‘Battery settings è Battery control mode
è Sensor member list’. Display of the average current in A.
n Total battery discharge current (MPPT 6000-M only): Total
battery discharge current of all components activated in the
menu ‘Battery settings è Battery control mode
è Sensor member list’. Display of the average current in A.
n Total battery charge/discharge power (MPPT 6000-M only): Total
power of all components activated in the menu ‘Battery settings
è Battery control mode è Sensor member list’. Display of the
average power in W.
756.404 | Z01 | 16.06 54