User manual

▶
Press ESC for 1 s. The standard status display appears.
1. Press SET. The Main menu appears.
2.
Press D, Ñ to select System settings (Fig. left).
3. Press SET. The System settings menu appears (Fig. left).
4.
Press D, Ñ to select Mode AUX IO.
5. Press SET. The Mode AUX IO
dialogue appears (Fig. left).
6.
Press D, Ñ to select the desired function.
7. Press SET. The selected function is activated.
8. Press ESC for 1 s. The standard status display appears.
Configuring Device On/Off control
NOTICE!
If the Device On/Off setting is not changed to Remote then the switching signal at the AUX
IO connection has no effect on the charging operation of the MPPT 6000-M.
1. Press SET. The Main menu appears.
2.
Press D, Ñ to select Device On/Off (Fig. left).
3. Press SET. The Device On/Off dialogue appears (Fig. left).
4.
Press D, Ñ to select Remote.
5. Press SET. The selected function is activated.
6. Press ESC for 1 s. The standard status display appears.
6.4 PA TS-S external temperature sensor connection
CAUTION!
Use only a Steca PA TS-S external temperature sensor approved for use with the device.
Incorrect sensors can lead to incorrect temperature compensation of the charge voltage and
damage the battery. Observe the safety notices in
Ä Chapter 4.1 ‘Safety instructions’
on page 23 when connecting the sensor.
756.404 | Z01 | 16.06 43