Datasheet

only with
TAROM
MPPT
6000-M
www.steca.com
Function overview of multifunctional contacts
and Communication options
Communication options
The StecaLink bus facilitates communication between a Steca Ta-
rom MPPT 6000-M and up to 22 further Steca Tarom MPPT 6000-S
units. The integration of accessories such as the electricity sensor
Steca PA HS400 is realised via the StecaLink bus. All currents and
other data are recorded in this way in the system and tracked in
the data logger. The charge controller determines and displays the
battery‘s current state of charge (SOC) (Steca PA HS400 required).
The connected Steca Tarom MPPT 6000-S units even continue wor-
king in a special redundancy mode when communication errors oc-
cur. The Steca Tarom MPPT 6000-M also has an RS-232 interface,
which can output all relevant system data once a minute. A MicroSD
card slot allows you to record comprehensive data for all devices in
the StecaLink communication system on a standard MicroSD card.
Professional control of loads and generators is possible via the mul-
tifunctional contacts.
The Steca Tarom MPPT 6000-M is equipped with three multifunc-
tional contacts, which can be programmed independently of one
another. These versatile individual functions can be combined vir-
tually as required:
Deep discharge protection
Deep discharge protection automatically protects the battery against
harmfully low levels of discharge. All voltage thresholds can be freely
configured via a menu based either on the battery‘s current state of
charge (SOC) or on the battery voltage.
Evening, night light and daylight function
The charge controller allows configuration of three different
automatic timer functions: evening light, night light and daylight.
All the important time and delay values can be set with this. With
the evening light function, the load is automatically switched on at
sunset and the time after which the load is switched off again can
be individually specified. The night light function specifies the time
after which the load is switched on after sunset and switched off
again before sunrise. With the morning light function, the load is
switched on automatically at night and automatically switched off
again at sunrise.
Four freely programmable timers with week day function
The four freely programmable timers can be set individually based
on day of the week, start and finish time. With the week day func-
tion, each timer can be used for just one or several days of the week
at a time if required.
Generator function
Using the generator function, the Steca Tarom MPPT 6000-M – ba-
sed on the SOC or the battery voltage – can start a generator auto-
matically when the battery is discharged, and switch this off again
when the battery is full. Using the surplus manager, an additional
load can be activated automatically when the battery is full. This is
switched off again as soon as no more energy surplus is available in
the solar system. This guarantees that all available energy is used.
Enjoy numerous added benefits!
User-friendly graphical LCD display
The graphical multifunction display of the Tarom MPPT 6000-M and
Tarom MPPT 6000-S displays all system states intuitively via icons.
This permits a clear understanding of the energy flow. All parameters
can be configured using the multi-lingual, intuitive menu.
SOLAR CHARGE CONTROLLERS