User manual

8.10 Clear log data
NOTICE!
– The entries in the internal data logger are deleted via the ‘Clear log data’ menu item.
–
The ‘Energy input total’ and ‘Energy output total’ information is not deleted.
– The Hours-of-operation value displayed in the measurements section of the status screen is
not deleted.
– The logged data on the SD card is not deleted.
Clear log data
✔
✔‘Main menu è System settings è Clear log data’
1. Press SET. The Clear internal log data dialogue appears
(Fig. left).
2. Press SET for 1 s. All internal log data, except for the total yield
data, is deleted.
8.11 Clear event log
See
Ä Chapter 10.2 ‘Event messages’ on page 111.
8.12 Factory settings
NOTICE!
– All active device functions are stopped when a factory reset is performed.
–
The values configured by a factory reset are specified in
Ä Chapter 12 ‘Technical data’
on page 124.
– Executing a factory reset deletes all settings and resets the values to the factory default
values. The device then performs a reset.
– Executing a factory reset also deletes data in the internal data logger. The operating hours
counter and the Energy input total/Energy output total values are retained.
– All application-specific settings must then be configured anew.
– Parameter settings that are not saved on an SD card are lost when a factory reset is
executed.
– Save the configured parameters on the SD card before executing a factory reset (MPPT
6000-M only).
– The settings can then be reloaded from the SD card after the device has restarted.
756.404 | Z01 | 16.06 99