User manual

‘No slave found’ – a StecaLink member device could not be
identified at the specified address. See Ä Chapter 10
‘Troubleshooting’ on page 111 for possible error correction
measures (see event message - Number 79).
‘Address already used’ - a StecaLink member device is already
registered under the specified address, see
Ä Chapter 10
‘Troubleshooting’ on page 111 for possible error correction
measures (see event message - Number 79).
Change slave settings
NOTICES
n Device-specific configuration of the slave registered at the
MPPT 6000-M is performed here.
n Different settings are available depending on the
functional scope of the slave.
✔
‘Main menu è System settings è StecaLink master menu
è Change slave settings
’
1. Press SET. The Change slave settings dialogue appears
with a list of the recognized StecaLink slave members. The list
is sorted by increasing order of the member addresses (Fig
left).
2.
Press D, Ñ to select the StecaLink slave member whose settings
are to be changed.
3. Press SET. The configuration menu for the selected slave
appears.
Further information on the individual configuration settings for
each respective slave is provided in the operating instructions
for the slave.
In the operating instructions for the PA HS400 current sensor.
In
Ä Chapter 8.8.3 ‘Changing the MPPT 6000-S slave settings
(MPPT 6000-M only)’ on page 87 of these operating
instructions for the MPPT 6000-S.
8.8.3 Changing the MPPT 6000-S slave settings (MPPT 6000-M only)
Topics
1.
Ä ‘Selecting the MPPT slave’ on page 88
2.
Ä ‘Changing Tarom MPPT 6000-S slave settings’ on page 88
3.
Ä ‘Configuring the operating mode’ on page 89
4.
Ä ‘Delete slave’ on page 90
5.
Ä ‘Synchronising slave’ on page 91
756.404 | Z01 | 16.06 87