User manual

1. Press SET. The Li-Ion temperature range dialogue
appears (Fig. left).
2. Press SET. The Min. temperature value flashes.
3.
Press D, Ñ to change the value.
4. Press SET. The value stops blinking.
5.
Press Ñ to select the Max. temperature value.
6. Press SET. The Max. temperature value flashes.
7.
Press D, Ñ to change the value.
8. Press SET. The value stops blinking.
8.6.7 Battery temperature sensor
NOTICE!
– For the Li-Ion battery type, the temperature sensor is used for monitoring the temperature
range configured for charging.
–
The charge voltage is not temperature compensated.
For settings see
Ä Chapter 8.5.11 ‘Battery temperature sensor’ on page 71.
8.6.8 Cable compensation
For the cable compensation settings, see
Ä Chapter 5 ‘Initial commissioning of the base
system’ on page 33.
8.6.9 PV string connection
For settings see
Ä Chapter 8.5.13 ‘PV string connection’ on page 71.
8.7 NiCd battery system functions (MPPT 6000-M only)
NOTICE!
– Ensure that all settings agree with the specifications provided by the manufacturer of the
NiCd battery. The initial default settings provided are not recommendations.
–
Observe the safety notices for the battery used.
– The scope of the Battery settings menu changes in comparison to the lead-acid/Li-Ion
settings when the NiCd battery type is selected.
– When the NiCd battery type is selected, the possible settings for the following functions
assigned to the AUX 1/2/3 outputs also change:
– deep discharge protection,
– generator control,
– excess energy control.
756.404 | Z01 | 16.06 77